Specify one of the following DNS servers in the Static DNS 1 field: The Endpoint Address and Peer Public Key in the example above are specific to our server in Sweden.Ĭlick the Save button, then click the Apply Settings button. Note: You are welcome to use whichever server you prefer. Peer Public Key: Enter an IVPN WireGuard server public key (available on the Server Status page).Endpoint Address: Enter an IVPN WireGuard server hostname (available on the Server Status page) and choose a port:.10.0.254.3 = AntiTracker Hardcore Mode to also block Google and Facebook.10.0.254.2 = standard AntiTracker to block advertising and malware domains.172.16.0.1 = redular DNS with no blocking.Peer Tunnel DNS: Specify one of the following DNS servers:. ![]() This will prevent out-bound traffic when the VPN client is disconnected from the server.Ĭlick the Add Peer button and enter the following peer configuration (as also shown in the screen shot below): This will display details of the WireGuard connection including the public key, which can be easily copied. Click the Save and Apply Settings buttons, then go to Administration > Commands and enter wg in the Commands box, then click Run Commands. Typically, they are disabled by default, but you might have installed other software that enabled them, or another user might have set them up.įor more information about disabling proxy servers in your web browser, see Bitdefender’s How to remove proxy settings in your browser support article.Hint: After clicking Generate Key, it may or may not be possible to copy the public key displayed on the Tunnels page. Proxy servers are configured in your web browser to hide your IP address. Make sure that proxy servers are disabled for your web browser. If the command line shows request timeouts, your computer is not connected to your router.If the command line shows ping failures, your computer is not connected to your router.If the command line shows replies from 192.168.1.1, your computer is connected to your router.Type ping 192.168.1.1 into the command prompt.Press the Windows button on your keyboard or click the Windows icon in the taskbar to open the Start menu.Use your computer's command prompt to test your router connection Follow the manufacturer’s instructions to troubleshoot your network adapter. If the Ethernet port LED is not lit, troubleshoot your network adapter. Check that the LED on your computer’s Ethernet port is lit.For more information, see How to resolve amber LEDs or a blinking power LED on NETGEAR routers. If the Internet LED is not lit, troubleshoot the Internet LED. Check that the Internet LED is lit on the router. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |